Article List
- The process of wort boiling in beer brewingThe boiling time in beer brewing should depend on the type of beer, brewing technique, etc. Typically, the boil time is about 70-90 minutes. Next, we'll cover the three processes of boiling: preheating, primary boiling, and boiling.
- Note for transferring beer to draft beer tanksAfter the beer completes the primary fermentation process, we need to transfer the draft beer to aseptic storage tanks for the secondary fermentation process. Transfer takes 1-3 days. The ideal method of transfer is to remove the air from the tank with water, then remove the water along with the carbon dioxide to avoid exposure of the beer to oxygen.
- The brewing process of beer equipment(1) We heat the HLT in advance at night or early morning to prepare hot water. (2) We transfer the calculated (according to the recipe) hot water (eg around 35°C) from the HLT to the MLT (the temperature can be adjusted/mixed by adding a water mixing device).
- How to clean brewery pipes?In breweries, pipes are complex components that require thorough cleaning. We have to make full use of mechanics to improve the cleaning effect, because the flow conditions have a great influence. If the flow rate is too slow, the liquid tends to stratify, and then the flow rate starts to slow down from the center to the edges. In this case, it is difficult to remove the dirt. Therefore, when cleaning the pipeline, it is necessary to ensure high speed to generate vortex.
- What are the factors affecting wort filtration in beer brewing?1. Thickness of wortThe hotter the temperature, the less consistent the wort and the faster the pulp emerges. 12 parts of Prato wort took 20% longer to gel than 15 parts of Prato wort.2. Grain bed resistanceThe grain bed resistance is the amount of resistance to all wort drainage.
- Technology of brewing beer with beer equipmentOnce the malting process is complete, mashing is the next process after developing the beer. This is the beginning of the sweet juice process that turns the whole mix into wort, to which the manufacturer needs to add yeast to start the basis of fermentation.
- Hygienic control factors in craft beer brewing processWith the improvement of our living standards, the gentrification and diverse preferences of beer have attracted more and more attention. Craft beer pursues high-quality satisfaction, drinks the best and healthiest beer, and manages the development process. The following are several healthy control f
- What are the two main yeasts in beer brewing?What are the two main yeasts in beer brewing?No two yeast strains have the same characteristics. The two main types of yeast used in beer equipment are: ale yeast and lager yeast.
- What are the requirements for site selection for a new microbrewery?With the development of the times, more and more people like to drink craft beer, and at the same time, more and more people are preparing to enter the industry and open their own breweries. We need to consider several aspects when building a brewery. Here are some site selection requirements for those who have no experience and want to open a brewery:
- Wort Filtration Technology in Beer BrewingFiltration systems are used throughout the brewing process, and most beers sold today are filtered to some extent. At the end of the saccharification process, the excipients have completed the breakdown of their macromolecules. Therefore, wort (a water-soluble extract) and distillers grains (residue, macromolecular proteins, cellulose, fat, etc.) must be separated in the shortest possible time. This separation process is called filtration of the mash.